Tooling, collet chucks, measuring, lathe tools, cutters, taps, vices, sleeves, arbours etc etc ISO 30, 40 & 50 R-8, 3 mt, 4 mt.

Call or email with your requirments.

Australian made Macbro pedestal grinder.
Fitted with 1 wire wheel.

Runs well.

Allen West & Co pedestal grinder made in England.
Runs well.

Assorted Australian Made 8” Grinders. 3 Phase. Includes stand if available.

$195 + g.s.t. Each.

Used Brobo-Waldown model 8SN pedestal drill, 4 speed, MT-2, Jackobs chuck with key, 3-Phase, made in Australia.
Ex-university, has been in storage.

Parkanson power hacksaw.

Runs smoothly.

Capacity approx 12 inches/300mm.

No blade.

Australian made Woodfast belt and disk sander / linisher.

350mm disk, usable belt area 650x150mm, tilting disk platten, 3 phase motor, comes with a range of spare belts and disks. suitable for wood or metals.

runs well but needs a tidy up.

Used Herless 11CUK Bench lathe

240v motor

280x610mm capacity

Metric and imperial.

Comes with 3 and 4 jaw chucks, faceplate, fixed steady, spare belts and a spare tailstock quill.

Australian made Purcell 'Record' Lathe.

17" swing over bed, 26" swing over gap. 48" between centers. 2 3/4" spindle bore. 30-1000 RPM in 12 steps. MT4 tailstock.

Comes with: 240mm 3 jaw chuck with change jaws, 310mm 4 jaw chuck, 430mm faceplate, Fixed and travelling steadies.

Pehaka vertical bandsaw 1000mm throat, 300mm cutting height, tilt table, variable speed 12-2000 m/min, blade welder, grinder blade size 3-12mm wide.

Bridgeport milling machine.

table 1220x230mm

travels 780x310x400mm

x-axis power feed

2hp variable speed head, R8 spindle taper.

2-axis mitutoyo readout

Used Mark 1 Colchester Student lathe.
Marked as 6 inch center height (actually 6.5) swing = 13" over bed.
24 inch between centers.
spindle bore just over 1.5 inch.
spindle speeds 34 - 1500 RPM
3HP motor 3-Phase.
Spindle is American L0 type.
MT3 tailstock.
Comes with 3 jaw chuck with 3 sets of jaws.

Bridgeport milling machine

table 1065x230mm

travels 690x310x400mm

x-axis power feed

1.5hp variable speed head, R8 spindle taper.

3 axis heidenhein readout

Used Taiwanese made Yeong Chin milling machine. One owner since new. Fitted with 1.5hp 240V single phase motor but also comes with 2hp 415v 3-phase motor and switch to suit.

8 speed belt drive head 80-2720 RPM

Table 1065x230mm

Travels 580x300x400mm

X-axis power feed.

Metric Trav-a-Dial dial readouts fitted on X and Y axis, accurate to 0.01mm.

one shot lube and coolant fitted.

Colchester Mascot 1600 lathe.

433 mm swing, 1000mm between centers. 76mm bore.

12.5hp motor, 16 spindle speeds.

3 and 4 jaw chucks, face plates.

2 axis heidenhein DRO

Coolant

Worklight